5-51
5-16 User Parameters
5
Operating Functions
Parameters Details
• This section provides an explanation for all parameters.
Be sure to fully understand the meanings of parameters before making changes to the parameter
settings.
Do not change the parameters marked “Reserved”.
Do not change the settings marked “Reserved”.
Function Selection Parameters (Pn00 to Pn0F)
• If communications with a computer or other host controller are used by multiple Units via RS-232
or RS-485, it is necessary to identify which Unit the host is accessing. With this parameter, the unit
number can be confirmed using alphanumeric characters.
• The unit number is determined by the unit number switch setting on the front panel when the power
supply is turned ON. This number is the unit number when using serial communications.
• The setting of this parameter has no effect on Servomotor operation.
• The setting of this parameter can be changed only by using the unit number switch on the front
panel.
Pn00
Unit No. Setting
Setting range 0 to 15 Unit --- Default setting 1
Power OFF→ON
Yes
To Next Page
Loading...
