Omtech PRO 3655 - Cleaning; Cleaning the Main Bay and Engraver

110
•
Disconnect the engraver from power before cleaning.
•
Completely wipe dry the surfaces after cleaning.
•
NEVER allow water to come into contact with the electronic elements.
*Depending on what you’ve been engraving, you might need to clean the
engraver more or less often. However, we suggest cleaning it after each use for
the best results.
8.2 Cleaning
8.2.1 Cleaning the Main Bay and Engraver
Main Bay & Engraver
*Cleaning Frequency: Daily, after each use
Tools Needed:
•
Paper towel
•
Mild detergent
Viewing Window
Clean with mild cleansers and a lens or cotton cloth. DO NOT use paper towels as they can scratch
the acrylic and reduce the cover’s ability to protect you from laser radiation.
Main Bay Interior
Clean thoroughly with paper towels, removing any debris or deposits.
Debris Tray
Step 1.
Turn off and unplug the engraver.
Step 2.
Slide out the tray.
Step 3.
Empty loose waste, rinse dust and fine debris off, dry, and replace the tray.
Other Surfaces
Dust the other surfaces with a soft cloth or clean them using a mild detergent and then wipe clean
before further use.