113
8.2.3 Cleaning the Mirrors
Camera, Mirrors, & Focus Lens
Cleaning Frequency: Daily, after each use
8. Maintenance
Tools Needed:
Lens brush
Laser-safe microfiber cloth/cotton swab
Alcohol/laser-safe cleaning solution
To clean Mirrors 1, 2, and 3.
Step 1. DISCONNECT THE MACHINE FROM POWER.
Step 2. Thoroughly wash and dry your hands.
Step 3. Bow any particulates off mirror surface.
Step 4. Drench the microfiber cloth in the cleaning solution, squeezing excess solution.
Step 5. Wipe clean the mirrors in gentle, cicular motion.
Step 6. Check the surfaces of the mirrors.
If any particulates or surface stains remain, repeat steps 3–6.
If any particulates or surface stains are still present after second cleaning, they are most likely
permanently burned into surface. Replace the mirrors.
The surfaces of these mirrors are scratch-prone. Avoid direct contact with
fingers or pressing hard, which could cause scratches by grinding debris into
the lenses.
Remember to let the clean fluid used for cleaning dry before further use.
The surfaces of these mirrors are scratch-prone. Avoid direct contact with
fingers or pressing hard, which could cause scratches by grinding debris into
the lenses.
Remember to let the clean fluid used for cleaning dry before further use.
Disconnect the engraver from power before cleaning.
To Next Page
Loading...
