6
•
DO NOT drain or fill the integrated water tank while it is connected to its power supply.
Disconnect the chiller and the laser from power before adjusting the cooling liquid level. Do not
allow any electronic component to become wet and, if any accidentally does become wet, leave
the entire system disconnected from power until all components are fully dry.
•
Adjustment, maintenance, and repair of the electrical components of this device must be done
ONLY by trained and skilled professionals to avoid fires and other malfunctions, including potential
radiation exposure from damage to the laser components. Because specialized techniques are
required for testing the electrical components of this marking system, it is recommended such
testing only be done by the manufacturer, seller, or repair service.
•
Unless otherwise specified, ONLY undertake adjustment, maintenance, and repair of the device
when it is turned off, disconnected from its power supply, and fully cooled. For maximum safety,
wait about 3 minutes after turning the machine off before adjusting the integrated chiller or other
electronic parts. This will allow time for the ground connection to clear any residual charge.
To Next Page
Loading...
