8
This machine CANNOT be used with the following materials or with any materials that include them
due to the toxic fumes they will release when being engraved:
•
Artificial Leather containing Hexavalent Chromium (Cr [VI])
•
Astatine
•
Beryllium Oxide
•
Bromine
•
Chlorine, including Polyvinyl Butyral (PVB) and Polyvinyl Chloride (PVC, Vinyl, Sintra, etc.)
•
Fluorine, including Polytetrafluoroethylenes (teflon, PTFE, etc.)
•
Iodine
•
Phenolic Resins, including various forms of Epoxy
•
Polycarbonate (PC, Lexan, etc.)
Besides TOXIC FUMES, fire hazard that could be cuased by highly reflective material is another
major issue. Thus, do not use on highly reflective metals, including aluminum, titanium, and copper.
For all other materials, if you are unsure about its safety or laserability with this device, seek
out its material safety data sheet (MSDS). Pay especial attention to information about safety,
toxicity, corrosiveness, reflectivity, and reaction(s) to high heat. Alternatively, contact our support
department for further guidance.
To Next Page
Loading...
