10
Non-Metal
Engraving
Non-Metal
Cutting
The water-cooling system or its equivalent must be used with this engraver to dissipate the
heat produced by the laser tube. Similarly, an exhaust system—typically either an external vent
or a dedicated air purifier—must be used with the provided fan to remove the dust and gases
produced by the engraving process. Never operate the engraver without both of these systems
operating properly. The cooling liquid should always be kept clean and below 104
℉
(40
℃
), and the
exhaust system should always comply with all applicable laws and regulations for workplace and
environmental air quality. The small amount of refrigerant in the integrated chiller should not be
dangerous under normal use, but only use this machine in well-ventilated areas and be careful to
avoid any sharp impacts, especially during transport and movement.
Finally, note that the active laser is invisible to the human eye. This device should never be used
while any cover is open to avoid potentially permanent injuries.
To Next Page
Loading...
