71
5. Typical Operation Sequence
Step 2. Once you have finished engraving, close your software and then turn off your machine in
the following order:
1. Turn and remove your laser key.
2. Turn the ammeter down.
3. Press the emergency stop.
4. Allow time for the ventilation and cooling systems to continue running, cooling the laser
and removing any remaining fumes or dust.
5. Turn off the external fan, and then the water chiller.
6. Flip down the circuit breaker at the rear of the engraver.
Step 3. Fully clean the workbed and check if the lens or any mirrors require cleaning. Use the
bottom left access panel to remove, empty, clean, and replace the debris tray. Store
everything neatly away.
To Next Page
Loading...
