Reset BIOS Firmware to Default Settings (Oracle ILOM)
For instructions, refer to your service manual.
1.
Access the BIOS Setup Utility.
For instructions, see “Accessing the BIOS Setup Utility” on page 34.
2.
Press the F9 key to automatically load the optimal default settings.
A message appears prompting you to continue this operation by selecting OK or to cancel this
operation by selecting CANCEL.
3.
In the message, highlight OK, and then press Enter.
4.
To save your changes and exit the BIOS Setup Utility, press the F10 key.
Alternatively, you can select Save and Exit from the Exit menu.
Reset BIOS Firmware to Default Settings (Oracle
ILOM)
Before You Begin
Ensure that you have Admin (a) role privileges in Oracle ILOM.
1.
To reset the BIOS firmware to default settings in the Oracle ILOM web interface:
a.
Log in to the Oracle ILOM web interface.
For instructions, see “Accessing Oracle ILOM” on page 21.
b.
In the navigation pane, click System Management → BIOS.
c.
In the Reset to Defaults drop-down list, select Factory.
d.
Click Save.
2.
To reset the BIOS firmware to default settings in the Oracle ILOM command-line
interface (CLI):
a.
Log in to the Oracle ILOM CLI.
For instructions, see “Accessing Oracle ILOM” on page 21.
b.
Type: set /System/BIOS reset_to_defaults=factory
Backing Up and Restoring Hardware and Firmware Configurations 101
To Next Page
Loading...
Need help?
General
