Oracle X7 series - Access the Oracle ILOM Diag Shell (CLI Only)

Access the Oracle ILOM Diag Shell (CLI Only)
■ ssh -l username host
or
■ ssh username@host
Where host is either the IP address or the host name of the server SP.
For example: ssh root@192.0.2.231
If this is the first time you are accessing Oracle ILOM, use root for the user name
and changeme for the password.
The Oracle ILOM password prompt appears.
c.
Type your password, and then press Enter.
Oracle ILOM displays a default command prompt (->), indicating that you have
successfully logged in.
Access the Oracle ILOM Diag Shell (CLI Only)
The Oracle ILOM diag shell is used to access the HWdiag diagnostic commands and to view
diagnostic logs.
For detailed information about the diagnostic programs, refer to Oracle x86 Servers Diagnostics
and Troubleshooting Guide With Oracle ILOM 4.0.x in http://www.oracle.com/goto/
x86admindiag/docs.
1.
Log in to the Oracle ILOM CLI.
The Oracle ILOM CLI prompt appears.
2.
At the Oracle ILOM prompt, access the ILOM Diag shell. Type:
->start /SP/diag/shell
Are you sure you want to start /SP/diag/shell (y/n)? y
The diag> prompt appears.
26 Oracle X7 Series Servers Administration Guide • September 2017