Oracle X7 series User Manual

Restore a Saved Oracle ILOM Firmware Configuration (Oracle ILOM)
b.
Use the set command:
set System/BIOS/Config restore_options=[all|config_only|bootlist_only]
load_uri=transfer_method://username:password@host/filepath
Where:
■
transfer_method is one of the following protocols: tftp, ftp, sftp, scp, http, or
https.
■
username and password are your credentials on the remote system where the backup
file is saved.
■
host is the IP address or hostname of the system where the backup file is saved.
■
filepath is the relative path to the backup file.
Note - If you transfer the backup file using TFTP, you do not need to provide a username or
password.
Related Information
■
Restore BIOS Configuration, Oracle ILOM Administrator's Guide for Configuration and
Maintenance, Firmware Release 4.0.x at http://www.oracle.com/goto/ilom/docs
Restore a Saved Oracle ILOM Firmware
Configuration (Oracle ILOM)
Before You Begin
Ensure that you have the privileges associated with the following roles in Oracle ILOM: Admin
(a), User Management (u), Console (c), and Reset and Host Control (r).
1.
To restore a saved Oracle ILOM configuration from the Oracle ILOM web
interface:
a.
Log in to the Oracle ILOM web interface.
For instructions, see “Accessing Oracle ILOM” on page 21.
b.
In the navigation pane, click ILOM Administration → Configuration
Management.
c.
Select Restore in the Operation drop-down list.
96 Oracle X7 Series Servers Administration Guide • September 2017

Oracle X7 series Specifications

General

Management	Oracle Integrated Lights Out Manager (ILOM)
Memory	DDR4
Storage	NVMe
Expansion Slots	PCIe
Form Factor	Rackmount
Operating System	Oracle Linux, Solaris