Oracle X7 series User Manual

Back Up the Current BIOS Firmware Configuration (Oracle ILOM)
■
“Back Up RAID Controller Configuration (Oracle Hardware Management
Pack)” on page 94
Back Up the Current BIOS Firmware Configuration
(Oracle ILOM)
Before You Begin
Ensure that you have Reset and Host Control (r) and Admin (a) role privileges in Oracle ILOM.
1.
To back up the current BIOS configuration in the Oracle ILOM web interface:
a.
Log in to the Oracle ILOM web interface.
For instructions, see “Accessing Oracle ILOM” on page 21.
b.
In the navigation pane, click System Management → BIOS.
c.
In the Backup section of the page, select a Transfer Method from the drop-
down list.
d.
Specify the destination of the exported configuration.
e.
Click Start Backup.
2.
To back up the current BIOS configuration in the Oracle ILOM command-line
interface (CLI):
a.
Log in to the Oracle ILOM CLI.
For instructions, see “Accessing Oracle ILOM” on page 21.
b.
Use the following command:
set /System/BIOS/Config/dump_uri=transfer_method://username:password@host/filepath
Where:
■
transfer_method is one of the following protocols: tftp, ftp, sftp, scp, http, or
https
■
username and password are your credentials on the remote system where the backup
file will be saved.
■
host is the IP address or hostname of the system where the backup file will be saved.
■
filepath is the relative path to the backup file.
90 Oracle X7 Series Servers Administration Guide • September 2017

Oracle X7 series Specifications

General

Management	Oracle Integrated Lights Out Manager (ILOM)
Memory	DDR4
Storage	NVMe
Expansion Slots	PCIe
Form Factor	Rackmount
Operating System	Oracle Linux, Solaris