Oracle X7 series User Manual

Accessing Oracle Hardware Management Pack
Note - Redirection is active is the status if set to either Operational or Connecting.
e.
When you are done, disable redirection by typing:
set /SP/services/kvms/host_storage_device/ mode=disabled
Related Information
■
Redirecting a Remote Image File, Oracle ILOM Administrator's Guide for Configuration
and Maintenance, Firmware Release 4.0.x at http://www.oracle.com/goto/ilom/docs.
Accessing Oracle Hardware Management Pack
Before using Oracle Hardware Management Pack, you must install it (unless you are running
Solaris 11.2 or newer), and you must install an operating system. After that, you can run Oracle
Hardware Management Pack commands from the operating system command line, and you can
configure and use the management agents.
For installation instructions, see:
■
“Installing Oracle Hardware Management Pack” on page 32
■
Oracle Hardware Management Pack Installation Guide
To get started, see the following procedures:
■
“Use Oracle Hardware Management Pack Commands ” on page 33
■
“Use the Oracle Hardware Management Pack Management Agents” on page 34
Installing Oracle Hardware Management Pack
To install Oracle Hardware Management Pack, you must download the installation files
from My Oracle Support. Then, you can run a graphical installer or install Oracle Hardware
Management Pack components manually.
Note - Oracle Hardware Management Pack is an integrated component of the Oracle Solaris
operating system and is called Oracle Hardware Management Pack for Oracle Solaris. Do not
download and use any version of Oracle Hardware Management Pack that is not specifically
qualified for the Oracle Solaris operating system.
32 Oracle X7 Series Servers Administration Guide • September 2017

Oracle X7 series Specifications

General

Management	Oracle Integrated Lights Out Manager (ILOM)
Memory	DDR4
Storage	NVMe
Expansion Slots	PCIe
Form Factor	Rackmount
Operating System	Oracle Linux, Solaris