Oracle X7 series User Manual

Configuring DNS Server Information on the SP
Configuring DNS Server Information on the SP
Auto DNS via DHCP is enabled by default. However, you can manually configure DNS Name
Servers and DNS Search Paths. To change DNS server information on the service processor, see
the following procedures:
■
“Configure DNS Server Information on the SP (Oracle ILOM)” on page 64
■
“Configure DNS Server Information on the SP (Oracle Hardware Management
Pack)” on page 65
Configure DNS Server Information on the SP
(Oracle ILOM)
1.
To configure DNS server information from the Oracle ILOM web interface,
perform the following steps:
a.
Log in to the Oracle ILOM web interface.
For instructions, see “Accessing Oracle ILOM” on page 21.
b.
In the navigation pane, click ILOM Administration → Connectivity, and then
click the DNS tab.
c.
To enable Oracle ILOM to automatically retrieve DNS information from a
DHCP server on the network, select the Enabled check box.
d.
If you did not enable Auto DNS via DHCP, enter one or more DNS server IP
addresses and search paths.
e.
Enter the DNS Timeout as an integer between 1 and 10.
f.
Enter the DNS Retries as an integer between 0 and 4.
g.
Click Save.
2.
To configure DNS server information from the Oracle ILOM command-line
interface (CLI):
a.
Log in to the Oracle ILOM CLI.
64 Oracle X7 Series Servers Administration Guide • September 2017

Oracle X7 series Specifications

General

Management	Oracle Integrated Lights Out Manager (ILOM)
Memory	DDR4
Storage	NVMe
Expansion Slots	PCIe
Form Factor	Rackmount
Operating System	Oracle Linux, Solaris