Oracle X7 series - Power off the Server Using the On;Standby Button; Power on the Server Using the On;Standby Button

Power Off the Server Using the On/Standby button
■
“Power the Server Off or On (Oracle ILOM)” on page 44
Power Off the Server Using the On/Standby button
1.
Locate the On/Standby button on the server front panel.
Refer to the server installation guide for the location of the Power button.
Note - The On/Standby button is recessed on most systems.
2.
Use a stylus or other pointed, non-conducting object to press the Power button.
■ To perform a graceful shutdown, press and quickly release the On/Standby
button.
■ To perform an immediate shutdown, press and hold the On/Standby button
for at least 5 seconds.
Caution - Data loss. An immediate shutdown abruptly closes all applications and files without
saving changes.
The server enters Standby power mode.
Caution - To completely power off the server, you must disconnect the power cords from the
back panel of the server.
Power On the Server Using the On/Standby button
1.
Ensure that the power supplies are connected to a power source.
2.
Verify that the server is in Standby power mode.
See “Server Power State Overview” on page 41.
3.
Locate the On/Standby button on the front panel of the server.
Refer to the server installation guide for the location of the Power button.
Note - The On/Standby button is recessed on most systems.
Controlling the Server Power State 43