Oracle X7 series User Manual

Restore a Saved Oracle ILOM Firmware Configuration (Oracle ILOM)
d.
In the Transfer Method drop-down list, select a transfer method.
e.
Specify the location of the XML file.
f.
If you specified a Passphrase when you exported the XML file, enter and
confirm the Passphrase.
If you included fault data in the backup, you can select Include Fault Data to restore
it. This selection is reserved for Oracle Service personnel when they replace the SP. It
requires a passphrase.
g.
Click Run.
Note - While the Restore operation is taking place, Oracle ILOM sessions are suspended. The
sessions resume after the Restore operation is complete.
2.
To restore a saved Oracle ILOM configuration in the Oracle ILOM command-line
interface (CLI):
a.
Log in to the Oracle ILOM CLI.
For instructions, see “Accessing Oracle ILOM” on page 21.
b.
Use the set command:
set /SP/Config passphrase=passphrase include_faultdata=[true|false]
load_uri=transfer_method://username:password@host/filepath
Where:
■
passphrase is the passphrase you specified when you exported the XML file. If you
did not specify a passphrase, do not set the passphrase property.
■
include_faultdata=true includes fault data in the restore, if fault data was included
in the backup. This selection requires a passphrase and is available with Oracle ILOM
3.2.6 or newer.
Note - The fault data backup and restore is reserved for Oracle Service personnel when
they replace the SP.
■
transfer_method is one of the following protocols: tftp, ftp, sftp, scp, http, or
https.
Backing Up and Restoring Hardware and Firmware Configurations 97

Oracle X7 series Specifications

General

Management	Oracle Integrated Lights Out Manager (ILOM)
Memory	DDR4
Storage	NVMe
Expansion Slots	PCIe
Form Factor	Rackmount
Operating System	Oracle Linux, Solaris