Oracle X7 series - Page 58

Modify iSCSI Virtual Drive Properties (BIOS)
The Port Configuration screen appears.
7.
In the Port Configuration screen, perform the following steps:
a.
Set the iSCSI Mode property to Enabled.
b.
Set the Internet Protocol property to IPv4.
c.
Set the Connection Retry Count property to 1.
d.
Set the Enable DHCP property to Enabled or Disabled to specify an
addressing method for the iSCSI initiator.
e.
If you set the Enable DHCP property to Disabled, specify the Initiator IP
Address, Initiator Subnet Mask, and Gateway.
58 Oracle X7 Series Servers Administration Guide • September 2017