Parker P Series User Manual

Parker Hannifin
P Series User Guide 253
0x260A Multi Turn Data ALL
Variabl
e
Format
Setting Range
Default
Value
Unit
Acces
sibility
PDO
Allocati
on
Change
Property
Stor
e
DINT
-
-
rev.
RO
Yes
-
No
Show the multi-turn data of multi-turn encoder.
0x260B Drive Temperature 1 ALL
Variabl
e
Format
Setting Range
Default
Value
Unit
Acces
sibility
PDO
Allocati
on
Change
Property
Stor
e
INT - -
℃
RO No - No
The temperature is measured with the built in temperature sensor in the drive’s
power board. When the measured value is 95 or above, the drive overheating alarm
1(AL-22) is set off.
0x260C Drive Temperature 2 ALL
Variabl
e
Format
Setting Range
Default
Value
Unit
Acces
sibility
PDO
Allocati
on
Change
Property
Stor
e
INT
-
-
o
C
RO
No
-
No
The temperature is measured with the built in temperature sensor in the drive’s
power board. When the measured value is 90 or above, the drive overheating alarm
1(AL-25) is set off.
0x260D Encoder Temperature ALL
Variabl
e
Format
Setting Range
Default
Value
Unit
Acces
sibility
PDO
Allocati
on
Change
Property
Stor
e
INT
-
-
o
C
RO
No
-
No
Shows the temperature measured by the built in sensor of serial encoders (when encoder format
(0x0201) is 4). When the measured 90 or above, the encoder heat (AL-26)sets off.
0x260E Motor Rated Speed ALL
Variabl
e
Format
Setting Range
Default
Value
Unit
Acces
sibility
PDO
Allocati
on
Change
Property
Stor
e
UINT
-
-
rpm
RO
No
-
No
Show the rated speed of the drive motor.
0x260F Motor Maximum Speed ALL
Variabl
e
Format
Setting Range
Default
Value
Unit
Acces
sibility
PDO
Allocati
on
Change
Property
Stor
e
UINT
-
-
rpm
RO
No
-
No
Show the drive’s maximum speed.
0x2610 Drive Rated Current ALL
www.comoso.com

Parker P Series Specifications

General

Brand	Parker
Model	P Series
Category	Servo Drives
Language	English