Pentax R-200 Series User Manual

39
• Select the item of interest in the same way as
in the mode for initial setting 5.
8.6 Example of changing an initial setting content
(selection of atmospheric correction)
This section describes the operating procedures for selecting “1.ATM CORR” in initial
setting 1 as an example of changing an initial setting content. Use this example as a reference
when changing other items because it is also applicable to the operating procedures for
changing them.
Access the screen for initial setting 1 by taking procedures “8.2 Enter the mode for initial
setting 1”.
Press [F5] [SELECT] to open the screen for selecting the atmospheric correction.
Press [F3] [ ] or [F4] [ ] to position the cursor at the desired item, then press [ENT] key
to select that item.
Pressing the [ENT] key selects the change of
selected item. Pressing the [ESC] key invalid
ates the change of selected item.
Pressing again the [ESC] key or [ENT] key quits the initial setting screen and usual start
screen appears.
1.AIM CORR ：ATM INPUT
2.PRISM CONST ：-30mm
3.SHEET CONST ： 0mm
4.CRV/REF CORR ：0.14
5.COMP AXIS
：
ON
1.ATM CORR ：ATM
2.PRISM CONST ：-30mm
3.SHEET CONST ： 0mm
4.CRV/REF CORR ：0.14
5.COMP AXIS
：
ON
1.ATM INPUT
2.ppm INPUT
3.
NIL
1.ATM CORR ：pp INPUT
2.PRISM CONST ：-30mm
3.SHEET CONST ：0mm
4.CRV/REF CORR ：0.14
5.COMP AXIS ：ON
1.ATM CORR ：ATM
2.PRISM CONST ：-30 ㎜
3.SHEET CONST ： 0 ㎜
4.CRV/REF CORR ：0.14
5.COMP AXIS
：
ON
1.ATM INPUT
2.ppm INPUT
3.NIL

Pentax R-200 Series Specifications

General

Brand	Pentax
Model	R-200 Series
Category	Measuring Instruments
Language	English