Pentax R-200 Series - Remote; Remote, Offset, Station, and H. Angle Function

22
4.5 Remote, Offset, Station, and H. angle function
4.5.1 Remote
Press [F5][PAGE] to view another MEASURE menu.
Press [F1][REMOTE] once and then quickly press this key again to measure your desired point
Coordinates by moving the telescope.
The displayed Coordinates automatically change according to your aiming point.
The Remote is a function of, so to speak, “Real-time offset”. If a reference point or offset point is
measured, the Coordinates of your aiming point are calculated based on the reference plane.
There are three calculation methods of Cylindrical face, Fixed plane and Rotated plane. They are
selected by the “Preference
”. Refer to “Remote method selection”. The calculations are performed
on the virtual planes.
To quit the Remote measurement, press [F1][REMOTE] twice again.
Reference
P.
1.
Cy
lin
de
r
2. Fixed
3
.R
otated
Station
Point
Remote
POT3
0.000m