17
Select 1. RECTANGULAR COORD. and press [ENT] to view
the STATION POINT SETUP screen.
The
/
mark is used to scroll up / down. 6. PC is
viewed by scrolling down.
4.1.1 Point name, PN, input
Press [ENT] to view the PN screen.
The [ENT] is used for both accepting the selected choice
and opening the input screen of the Coordinates values
etc..
Input your desired point name by pressing keys, and after all Characters are input, press [ENT].
Four character selection methods are available. (Refer to the “13.3 Input method selection
”)
4.1.2 Coordinates, X, Y, Z, IH, and PC input
It goes 2. X coordinate automatically.
Press [ENT] to view the X coordinate input screen.
Input X, Y and Z coordinates, Instrument height and PC as
follows.
Input your desired X coordinate value by pressing each
keys.
Y coordinate:
Press [ENT] to view the Y coordinate input screen. Input
your desired Y coordinate value by pressing keys.
Z coordinate:
Press [ENT] to view the Z coordinate input screen. Input
your desired Z coordinate value by pressing each keys.
To Next Page
Loading...
Need help?
General
