26
Input the TEMP value.
Press [ENT].
Input the PRESS value.
Press [ENT].
Input ppm value.
Press [ENT].
TEMP, PRESS and ppm input depend on the “Initial setting 1”
(ATM INPUT, ppm INPUT, NIL).
4.7 Station Orientation
Press the [F5][ACCEPT] to view the STATION POINT H. ANGLE SETUP screen.
Input your desired H.angle.
Please, note that the rotation of the
“H.angle” depend on the rotation setting
of “Coordinate axis definition
”.
z [INVERS] key
If you want to calculate direction angle, Press [F1][INVERS] to jump to INVERSE
function.
Input SP as station point, EP as back sight point.
Result angle is set here automatically by pressing [ENT] at
RESULT OF INVERSE screen.
To Next Page
Loading...
