41
3. Selection of the quick measuring:ON/OFF
4. Selection of Long range message
: [LONG RANGE MES.]
5. Selection of Laser plummet : [LD PLUM.]
Laser plumb ON/OFF is selected.
6. Selection of Minimum angle display: [MIN UNIT ANG.]
Select whether to set the minimum angle display mode to
“COARSE (5 seconds)” or “FINE (1 second)”.
7. Selection of Vertical angle style: [V.ANG. STYLE]
Select whether the 0 point for vertical angle is set to be
“Z.0”, “H.0” or “COMPAS”.
8. Selection of Automatic power-off function
: [AUTO OFF]
Select the time interval (10, 20 or 30 minutes) for
activating the automatic power-off function, or select NIL,
disabling the function.
• The automatic power-off function automatically turns the power supply off after the
specified period of time (in minutes) when no operation for distance measurement or for key
entry has been performed with the angle remaining unchanged.
9. Selection of Distance measurement automatic power-
off function: [EDM OFF]
Select the time interval (3, 5, or 10 minutes) for activating the
distance measurement automatic power-off function, or select
NIL, disabling the function.
10. Selection for H.angle 90° buzzer: [QUAD. BUZ]
Select whether to enable or disable the beep at every 90°
during angle measurement.
8.9 Initial setting 4
1. Selection of Temperature unit setting: [TEMP. UNIT]
Select °C or °F as the unit for Temperature.
2. Selection of Pressure unit setting: [PRESS UNIT]
Select hPa (hectopascal), mmHg, inchHg as the unit for
pressure to be input.
X1.ﾟ CXXXXXXXXXX
2.ﾟ F
X1. hPa XXXXX
2. mmHG
3.inchHG
1.COARSE
X2.FINEXXXXXXXXX
X1.OFF XaXXXXXX
2.ON
X1.OFF XaXXXXXX
2.ON
X1.OFF XaXXXXXX
2.ON
X1.10 MIN XXX
2.20 MIN
3.30 MIN
4.NIL
X1. 3 MIN XXX
2. 5 MIN
3.10 MIN
4.NIL
X1.OFF XaXXXXXX
2.ON
X1.Z.0 XXXXX
2.H.0
3.COMPAS
To Next Page
Loading...
Need help?
General
