14–28
1. Park the vehicle on a level surface.
2. Shift the manual transmission lever in
neutral, or the automatic transmission
lever in P.
3. Stop the engine and depress the brake
pedal several times until the travel
distance does not change.
4. Start the engine with the brake pedal
depressed. The brake pedal should move
down slightly.
5. Stop the engine with the brake pedal
depressed. Hold the pedal for about 30
seconds. The pedal should not move.
6. Start the engine and stop it after about a
minute. Firmly depress the brake pedal
several times. The pedal travel distance
should decrease with each application.
w WARNING
If you notice any malfunction, have
the system checked immediately by an
authorised Perodua Service Centre.
Brake booster operation check
w WARNING
Make sure the ignition switch is in
“LOCK” or “OFF”, before replacing
the wiper blades.
CAUTION
Be careful not to scratch the glass with
the wiper frame.
Fix the blade with suitable length.
Wiper blade replacement
Claw
1. Raise the wiper arm from the windshield.
2. Press the claw and unlock the wiper blade
to seperate it from the arm.
Front
Sect 14_EN D42L.indd 28 31/10/2019 5:38 PM
To Next Page
Loading...
