16
Controls
7.03 Pedal
The function method of the pedal
depends on the selected
pedal mode (level or fl ip-fl op
mode), see Chapter 11 .04 Further
settings
0 = neutral position
+
1 = lower top feed roller
+2 = engage heating element /
sealing start
+3 = Cut tape / switch to cold or hot press
-1 = stop sealing operation /
raise top feed roller
Fig. 7 - 03
Fig. 7 - 02
7.02 Main switch
● The machine is switched on or off by tur-
ning main switch 1.
Position "0" : Machine is switched off
Position "1" : Machine is switched on
After the machine has been
switched on, fi rst of all the
"basic position" function must
be pressed, see Chapter 8.03
Switching the machine on/off.
1
+3
+2
+1
0
-1
To Next Page
Loading...
Need help?
General
