Heat sealing
35
10.02 Manual heat sealing
In the "Manual heat sealing" mode, all relevant parameters for the sealing operation can
be entered or altered directly, see Chapter 9.04 Entering the sealing parameters (manual
heat sealing).
● Select "manual heat sealing", see Chapter 9.03 Selecting the production type.
Description of the functions
Selecting a program
This function opens the menu for entering the program number or for selecting the produc-
tion type, see Chapter 9.03 Selecting the production type.
Pressing
This function is used to switch on the pressing function. It is possible to choose between
two pressing functions:
- Cold pressing
- Warm pressing
The pedal function is used to switch between cold and warm pressing, see Chapter 7.03 Pe-
dal. During cold pressing the rollers are closed with the set roller pressure. The rollers roll
over the part without tape, with disengaged hot air nozzle. During cold pressing the speed
can be infi nitely adjusted with the pedal function. The differential is switched off. During
warm pressing, the hot air nozzle is also engaged.
Heat sealing temperature
These functions are used to alter the heat sealing temperature, see Chapter 9.04.01
Entering the sealing temperature.
Feed stroke (sealing speed)
These functions are used to alter the feed stroke or to open the menu for entering the feed
stroke difference, the brake and acceleration profi les and the start delay for the feed rollers,
see Chapter 9.04.02 Entering the sealing speed.
Nozzle type / hot air volume
These functions are used to alter the hot air volume or to open the menu for choosing the
nozzle type, see Chapter 9.04.03 Choice of the nozzle type and hot air volume …
2x
To Next Page
Loading...
Need help?
General
