Heat sealing
36
Roller pressure
These functions are used to alter the roller pressure, see Chapter 9.04.04 Entering the rol-
ler pressure.
Start
(This function appears when the top feed roller is lowered.)
With this function the sealing start is called up, analog to the pedal function "+2", also see
Chapter 7.03 Pedal.
Feed roller up/down
With this function the top feed roller, depending on its position, can be raised or lowered,
analog to the pedal functions "-1" and "+1", also see Chapter 7.03 Pedal.
Feed rollers in reverse
This function makes it possible to call up the reverse running function of the feed rollers.
Tape cutting
This function starts a tape cutting operation.
Input menu
This function is used to call up the Input Menu, see Chapter 11 Input.
Stop
(This function appears during the sealing operation.)
This function is used to stop the sealing operation, analog to pedal function "-1", also see
Chapter 7.03 Pedal.
To Next Page
Loading...
Need help?
General
