Heat sealing
54
Feed roller up/down
This function is use to raise or lower the top feed roller, depending on its position, analog to
the pedal functions "-1" and "+1", also see Chapter 7.03 Pedal.
Feed rollers in reverse
This function makes it possible to call up the reverse running function of the feed rollers.
Tape cutting
This function starts a tape cutting operation.
Input menu
This function is used to call up the Input Menu, see Chapter 11 Input.
Stop
(This function appears during the sealing operation.)
This function is used to stop the sealing operation, analog to pedal function "-1", also see
Chapter 7.03 Pedal.
10.08 Error messages
In case of a malfunction, an error code appears on the display. An error message may be
caused by incorrect handling, faults on the machine or by overload conditions.
For the explanation of the error code, see Chapter 13.11 Explanation of the error numbers.
● Eliminate the error.
● Acknowledge the elimination of the error.
or
● Call up the input menu to eliminate the error with the service functions.
ERROR :
To Next Page
Loading...
Need help?
General
