Heat sealing
46
10.04.07 Example of how to enter a sealing program
The following example should be fi led under program number "10" with the comment
"EXAMPLE 1", and consists of three seam zones:
- Seam zone 1 with switch to another zone after 200 mm seam length
- Seam zone 2 with reduced sealing speed and speed difference between the top and
bottom feed roller, and switch to another zone after 100 mm
- Seam zone 3 with original sealing speed without speed difference between the feed
rollers and with switch to another zone after 400 mm
● Switch on the machine.
● Call up the input menu.
● Call up the programming function.
● Enter program number "10".
● Confi rm input.
The sealing parameters from the manual sealing mode are taken over for the 1
st
seam
zone.
To Next Page
Loading...
