Adjustment
72
● Switch on the machine and set the sealing temperature to its minimum value.
Let the heating element cool down!
Danger of burns if the heating element is touched!
● Call up the input mode.
● Position the heating element.
● Adjust screw 1 (screws 2) in accordance with requirement .
● Switch off the machine.
13.04 Adjusting the hot air nozzle
13
.04.01 Lateral adjustment
Requirement
When hot air nozzle 3 is engaged, seen in the feed direction it should be centred to the
feed roller 4.
Fig. 13 - 02
1
2
3
2
3
4
To Next Page
Loading...
