Care and Maintenance
69
12.04 Changing the feed rollers
● Switch on the machine and set the sealing temperature at its minimum value.
Let the heating element cool down!
Danger of burns if the heating element is touched!
● Call up the input menu.
● Lock the feed rollers.
● Change feed roller 1 (screw 2).
● Remove cover 3 (screws 4). If necessary help by placing Allen key through hole 5.
● Remove feed roller 6 (screw 7) with sleeve 8.
● Position new feed roller 6 with sleeve 8 and fasten with screw 7.
● Screw on cover 3 (screws 4).
If there is a difference between the diameters of the old and new feed rollers,
the machine must be re-confi gured, see Chapter 13.10.01 Machine confi gura-
tion.
● Check the position of the feed rollers and correct it if necessary, see Chapter 13.03 Ad-
justing the feed rollers.
● Switch off the machine.
6
8
Fig. 12 - 02
3
4
7
1
2
5
4
To Next Page
Loading...
