Preparation
30
9.04.02 Entering the sealing speed
● Increase or reduce the value for the sealing speed directly.
or
● Call up the fi gure panel to enter the sealing speed.
● If necessary call up the fi gure panel to enter the speed difference between the top and
bottom feed roller.
● Enter the value for the speed difference within the permitted range.
● The speed difference results from the change in speed of the top feed roller, which ro-
tates either more quickly or more slowly than the bottom feed roller. The value for the
speed difference depends on the material and application.
● Conclude the input, permissible values will be taken over.
● Enter the value for the sealing speed within the permissible range.
● Conclude the input, permissible values will be taken over.
To Next Page
Loading...
