Input
56
Daily piece counter
This function is used to call up the daily piece counter. The daily piece counter can be reset
with the Clear function.
Tape parameters
This function is used to open a menu for entering the tape parameters, see Chapter 11 .03
Tape parameters.
Pause
This function is used to switch off the temperature control of the heating element. The hea-
ting element cools down.
Programming
These functions are used to enter the function for creating and editing seam programs, see
Chapter 10.03 Creating/editing seam programs.
Pre-heating the feed rollers
This function is used to switch the automatic pre-heating function of the feed rollers on or
off. When the function is activated, a menu opens for entering the pre-heating time.
Feed rollers forwards
This function makes it possible to turn the feed rollers forwards at a freely selectable speed.
For this purpose a menu is opened with functions for selecting the speed of the feed rollers
and for starting or stopping the feed rollers.
Feed rollers backwards
This function makes it possible to turn the feed rollers backwards at a freely selectable
speed. For this purpose a menu is opened with functions for selecting the speed of the feed
rollers and for starting or stopping the feed rollers.
Positioning the heating element
With the use of this function, the heating element can be engaged manually to facilitate the
positioning of the heating element to the feed rollers. A menu is opened with functions for
carry out the engaging or disengaging operation.
Locking the feed rollers
This function is used to lock the feed rollers in order to facilitate a feed roller change. A menu
is opened with a function for releasing the lock again.
To Next Page
Loading...
Need help?
General
