Input
63
Sealing mode
This function is used to change to the sealing mode.
Acceleration and brake profi les
This function is used to enter the values for the corresponding acceleration or brake profi les.
Feed roller pressure limit
This function is used to enter the maximum permissible value for the feed roller pressure.
Basic position of the top feed roller
This function is used to select the basic position of the top feed roller. The basic position of
the feed roller can be raised or lowered.
Feed difference inkrement
This function is used to enter the inkrement of the feed difference.
Tape up/down
These functions are used to move the tape forwards and back.
Tape fi xation
These functions are used to fi x the tape in the band guide unit or release the tape from it.
(symbol shown inverse).
Tape cutting
This function starts a tape cutting operation (Reference cut).
#.#
bar
#.#
%
To Next Page
Loading...
