Planet IGS-10020HPT-U - Wall Mount Plate Mounting

User’s Manual of IGS-10020HPT-U
34
2.2.3 Wall Mount Plate Mounting
To install the I Industrial Managed PoE+ Switch on the wall, please follow the instructions below.
Follow all the DIN-rail installation steps as shown in the example.
Step 1: Remove the DIN-rail bracket from the Industrial Managed PoE+ Switch. Use the screwdriver to loosen the screws to
remove the bracket.
Step 2: Place the wall-mount plate on the rear panel of the Industrial Managed PoE+ Switch.
Step 3: Use the screwdriver to screw the wall-mount plate on the Industrial Managed PoE+ Switch.
Step 4: Use the hook holes at the corners of the wall mount plate to hang the Industrial Managed PoE+ Switch on the wall.
Step 5: To remove the wall-mount plate, reverse the steps above.