User’s Manual of IGS-10020HPT-U
375
The page includes the following fields:
Object Description
• Image
The flash index name of the firmware image. The name of primary (preferred)
image is image, the alternate image is named image.bk.
• Version
The version of the firmware image.
• Date
The date when the firmware was produced.
Buttons
: Click to use the alternate image. This button may be disabled depending on system state.
4.9.1.8 Factory Default
You can reset the configuration of the Industrial Managed PoE+ Switch on this page. Only the IP configuration is retained. The
new configuration is available immediately, which means that no restart is necessary. The Factory Default screen in Figure
4-9-1-10 appears.
Figure 4-9-1-10: Factory Default Page Screenshot
Buttons
: Click to reset the configuration to Factory Defaults.
: Click to return to the Port State page without resetting the configuration.
To reset the Industrial Managed PoE+ Switch
to the Factory default setting, you can also press the
hardware reset button on the front panel for about 10 seconds. After the device is rebooted, you can log
the management Web interface within the same subnet of 192.168.0.xx.
To Next Page
Loading...
