User’s Manual of IGS-10020HPT-U
40
3. SWITCH MANAGEMENT
This chapter explains the methods that you can use to configure management access to the Industrial Managed PoE+ Switch.
It describes the types of management applications and the communication and management protocols that deliver data
between your management device (workstation or personal computer) and the system. It also contains information about port
connection options.
This chapter covers the following topics:
Requirements
Management Access Overview
Command Line Interface Access
Web Management Access
SNMP Access
Standards, Protocols, and Related Reading
3.1 Requirements
The Industrial Managed PoE+ Switch provides local and remote login interface for management purposes. The
following equipment is necessary for further management:
Workstations running Windows XP/2003/2008/2012/Vista/7/8/10/11, MAC OS X or later, Linux, UNIX, or other platforms are
compatible with TCP/IP protocols.
Serial Port Connection (Terminal)
The above Workstations have been installed with terminal emulator, such as Hyper Terminal included in Windows
XP/2003, putty or tera term.
USB cable -- one end is attached to the USB port, while the other end to the micro USB connector of the Industrial
Managed PoE+ Switch.
Ethernet Port Connection
Workstations are installed with Ethernet NIC (Network Interface Card)
Network cables -- Use standard network (UTP) cables with RJ45 connectors.
The above PC is installed with Web browser.
Note:
It is recommended to use Chrome 98.0.xxx or above to access the Industrial Managed PoE+ Switch. If the Web
interface of the Industrial Managed PoE+ Switch is not accessible, please turn off the anti-virus software or firewall
and then try it again.
To Next Page
Loading...
