User’s Manual of IGS-10020HPT-U
151
4.3.3.8.3 Port Isolate
The diagram shows how the Industrial Managed PoE+ Switch handles isolated and promiscuous ports, and the each PC is
not able to access the isolated port of each other’s PCs. But they all need to access with the same server/AP/Printer. This
section will show you how to configure the port for the server – that could be accessed by each isolated port.
Setup steps
1. Assign Port Mode
Set Port-1~Port-4 in Isolate port.
Set Port5 and Port-6 in Promiscuous port. The screen in Figure 4-3-3-15 appears.
Figure 4-3-3-15: The Configuration of Isolated and Promiscuous Port
To Next Page
Loading...
