Polycom CX5100 - Page 50

Configuration Parameters
Polycom, Inc. 50
device.net.cdpEnabled
1
0 or 1
If set to 1, the system attempts to determine its VLAN ID and negotiate power through CDP.
device.net.dot1x.anonid
1
string
EAP-TTLS and EAP-FAST only. The anonymous identity (user name) for 802.1X authentication.
device.net.dot1x.enabled
1
0 or 1
If 0, 802.1X authentication is disabled. If 1, 802.1X authentication is enabled.
device.net.dot1x.identity
1
string
The identity (user name) for 802.1X authentication.
device.net.dot1x.method EAP-None,
EAP-TLS,
EAP-PEAPv0-
MSCHAPv2,
EAP-PEAPv0-
GTC,
EAP-TTLS-MS
CHAPv2,
EAP-TTLS-GT
C, EAP-FAST,
EAP-MD5
Specify the 802.1X authentication method, where EAP-NONE means no authentication.
device.net.dot1x.password
1
string
The password for 802.1X authentication. This parameter is required for all methods except EAP-TLS.
device.net.etherModeLAN
1
Auto, 10HD,
10FD, 100HD,
100FD,
1000FD
The LAN port mode that sets the network speed over Ethernet. HD means half-duplex and FD means full duplex.
Note: Polycom recommends that you do not change this setting.
device.net.etherModePC
1
Disabled,
Auto, 10HD,
10FD, 100HD,
100FD,
1000FD
Auto
The PC port mode that sets the network speed over Ethernet. If set to Disabled, the PC port is disabled. HD means
half duplex and FD means full duplex.
device.net.etherStormFilter
1
0 or 1
Device Parameters (continued)
Parameter Permitted
Values
Default