Polycom CX5100 - Page 51

Configuration Parameters
Polycom, Inc. 51
If 1, DoS storm prevention is enabled and received Ethernet packets are filtered to prevent TCP/IP stack overflow
caused by bad data or too much data. If 0, DoS storm prevention is disabled.
device.net.etherVlanFilter
1
0 or 1
VLAN filtering is done by the Linux operating system and it cannot be disabled.
device.net.ipAddress
1
string
The system’s IP address. Note: This parameter is disabled when DHCP is enabled (device.dhcp.enabled is set
to 1.
device.net.IPgateway
1
IP address
The system’s default router.
device.net.lldpEnabled
1
0 or 1
If set to 1, the system attempts to determine its
VLAN ID and negotiate power through LLDP.
device.net.subnetMask
1
subnet mask
The system’s subnet mask. Note: This parameter is disabled when DHCP is enabled (device.dhcp.enabled is
set to 1).
device.net.vlanId
1
Null, 0-4094
The system’s 802.1Q VLAN identifier. If Null, no VLAN tagging.
device.prov.maxRedunServers
1
1 to 8
The maximum number of IP addresses to use from the DNS.
0 or 1 1
If set to 1, the system will attempt to check for the latest version available on update server.
device.prov.password
1
string
The password for the system to log in to the provisioning server. Note that a password may not be required. Note: If
you modify this parameter, the system re-provisions. The system may also reboot if the configuration on the
provisioning server has changed.
device.prov.redunAttemptLimit
1
1 to 10
The maximum number of attempts to attempt a file transfer before the transfer fails.
When multiple IP addresses are provided by DNS, 1 attempt is considered to be a request sent to each server.
device.prov.redunInterAttemptDelay
1
0 to 300
The number of seconds to wait after a file transfer fails before retrying the transfer. When multiple IP addresses are
returned by DNS, this delay only occurs after each IP has been tried.
device.prov.serverName IP address,
domain name
string, or URL
Device Parameters (continued)
Parameter Permitted
Values
Default