Polycom CX5500 Unified Conference Station Administrator’s Guide 1.1.0
Polycom, Inc. 132
Web Info: Using a Different IP multicast address
The Group Paging feature uses an IP multicast address. If you want to change the default IP
multicast address, ensure that the new address does not already have an official purpose as
specified in the IPv4 Multicast Address Space Registry.
You specify the same IP multicast address in the parameter ptt.address for Paging mode. Paging
administrator settings shown in the table Configure Group Paging are located in the site.cfg template file.
Page group settings are located in the features.cfg template file.
Configure Group Paging
Central Provisioning Server
Specify the IP multicast address used for the paging feature
site.cfg > ptt.pageMode.enable
site.cfg > ptt.pageMode.displayName
Specify settings for all Page groups
features.cfg > ptt.pageMode.group.*
Web Configuration Utility
To specify the IP multicast address and port, and available paging groups for Group Paging, navigate to Settings
> Paging/PTT Configuration and expand Settings and Group Paging Configuration.
Local Phone User Interface
Specify the IP multicast address and port, and available paging groups for Group Paging from the Paging/PTT
Configuration menu, accessible from Settings > Advanced > Admin Settings.
Users can access basic Group Paging settings from Settings > Basic > Preferences > Paging/PTT
Configuration.
Web Info: Configuring Group Paging
Though the example configurations in this section will get you started, Polycom recommends that
you become familiar with the following document before using the PTT or Paging features:
Feature Profile 62327: Broadcasting Audio Messages with Group Paging and Push-to-Talk.
To Next Page
Loading...
Need help?
General
