Polycom CX5500

Polycom CX5500 Unified Conference Station Administrator’s Guide 1.1.0
Polycom, Inc. 243
<callLists/>
The call lists (or call log) parameters are listed in the table Call List (Call Log) Parameters.
Call List (Call Log) Parameters
Parameter
Permitted Values
Default
callLists.collapseDuplicates
0 or 1
1
If 0, all calls are archived and presented in the call lists. If 1, consecutive incomplete between the same party in
the same direction (outgoing/incoming) are collapsed into one record with the most recent call displaying.
callLists.logConsulationCalls
0 or 1
0
If 1, all consultation calls are logged. (Calls made to a third party—while the original party is on hold—when
settings up a conference call are called consultation calls.)
If 0, consultation calls are not logged.
callLists.size
10 to 99
99
The maximum number of retained records of each type (incoming, outgoing, and missed). When the maximum
number is reached, new records will overwrite existing records. You can clear the list using the phone’s menu
system. If you want to prevent the records from uploading to the provisioning server, enter a false URL in the
CALL_LISTS_DIRECTORY field in the master configuration file.
callLists.writeDelay.journal
1 to 600
5
The delay (in seconds) before changes due to an in-progress call are flushed to the file system as a journal.
callLists.writeDelay.terminated
10 to 600
60
The minimum period between writing out the complete XML file to the local file system and, optionally, to the
provisioning server.
<device/>
The <device/> parameters—also known as device settings—contain default values that you can use to
configure basic settings for multiple phones.
Web Info: Default Device Parameter Values
The default values for the <device/> parameters are set at the factory when the phones are
shipped. For a list of the default values, see the latest Shipping Configuration Notice.
Polycom provides a global device.set parameter that you can enable for software installation and
changes to device parameters. Once you have completed the software installation or made configuration
changes to device parameters, remove device.set. Disabling the parameter after the initial software
installation prevents the phones from rebooting and triggering a reset of device parameters that users
may have changed after the initial installation.