Polycom G7500 - Share Content Casted from AirPlay or Miracast; Share Content Using an HDMI Connection

Configuring Network Settings
Topics:
▪ Configuring Wired LAN Settings
▪ Configure Wi-Fi Settings
▪ Configure Network Quality Settings
▪ Configure H.323 Settings
▪ Configure SIP Settings
▪ Enable Point-to-Point Call Escalation to a RealPresence DMA Conference Call
▪ Wireless Devices
Network settings include the G7500 system primary (wired LAN) and secondary (Wi-Fi) network
configurations. You also can register your system with SIP and H.323 for calling.
Configuring Wired LAN Settings
You can set the wired LAN properties for your G7500 system.
Related Links
LED Status Indicators for the System LAN Ports on page 112
Obtain IPv4 Address Settings Automatically
You can configure the G7500 system to obtain its IPv4 addresses automatically.
You must have a DHCP server deployed in your environment.
Procedure
1. In the system web interface, go to Network > Primary Network > IP Addresses.
2. For IP Address, select Obtain IP address automatically.
Some of your IP address settings populate automatically and are read-only.
3. Select Save.
Configure IPv4 Address Settings Manually
You can configure the IPv4 settings for your G7500 system.
Procedure
1. In the system web interface, go to Network > Primary Network > IP Addresses.
2. For IP Address, select Enter IP address manually.
3. Configure the following settings:
Setting Description
Your IP Address is Specifies the system IP address.
Polycom, Inc. 27