Setting Description
Autonegotiation
(under General Settings in the local interface)
Specifies whether the system should automatically
negotiate the LAN speed and duplex mode per
IEEE 802.3 autonegotiation procedures. If you
enable this setting, the system sets LAN Speed
and Duplex Mode to read-only.
Polycom recommends that you use autonegotiation
to avoid network issues.
LAN Speed
(under General Settings in the local interface)
Specifies whether to use 10 Mbps, 100 Mbps, or
1000 Mbps for the LAN speed. Note that the switch
must support the speed you choose. If you enable
the Autonegotiation setting, this setting is read-
only.
Duplex Mode
(under General Settings in the local interface)
Specifies the duplex mode to use. Note that the
switch must support the speed you choose. If you
enable the Autonegotiation setting, this setting is
read-only.
Ignore Redirect Messages Enables the system to ignore ICMP redirect
messages.
Polycom recommends that you enable this setting
in most circumstances.
ICMP Transmission Rate Limit (millisec) Specifies the minimum number of milliseconds
between transmitted packets. Enter a number
between 0 and 60000. The default value of 1000
means the system sends 1 packet per second. If
you enter 0, the system disables the transmission
rate limit.
This setting applies only to “error” ICMP packets.
This setting has no effect on “informational” ICMP
packets, such as echo requests and replies.
Generate Destination Unreachable Messages Generates an ICMP Destination
Unreachable message if the system can’t deliver
a packet to its destination for reasons other than
network congestion.
Respond to Broadcast and Multicast Echo
Requests
When enabled, your system sends an ICMP Echo
Reply message in response to a broadcast or
multicast Echo Request that isn’t specifically
addressed to the system.
Enable LLDP
(under General Settings in the local interface)
Specifies if you want the system to advertise itself
on the network using the Link Layer Discovery
Protocol (LLDP). Enable if you want your system to
operate on a virtual LAN (VLAN).
Configuring Network Settings
Polycom, Inc. 29
To Next Page
Loading...
Need help?
General
