Viewing Logged Error Codes
Error event codes are logged, stored, and viewed in either the Error Log or CPA Event Log
menus depending on the console model, see ."Error Log & CPA Event Log" on page145
P10, P20, and P30: access Information Display (6,5) > select Error Log.
TIP: Deleting Error Codes from the Error Log: Press and hold the PAUSE/RESET
key for a minimum of 6 seconds to open the Error Log and view all logged error codes.
If there are no logged error codes, the "Stuck Key" message will show. To remove
error codes, select the error code and press/hold the QUICK START key until the
"NO ERRORS" message shows.
P62, P80, and P82: Access Hardware Validation (5,1,7,6,5,7,6,1) > select About > CPA
Event Log
Note: Unlike the Error Log, error codes cannot be manually removed from the CPA
Event Log.
Available Error Codes
A complete list of error codes including the code description, related issues/symptoms,
troubleshooting, and repair information is provided in the
Error Code Troubleshooting Guide
,
see Error Code Troubleshooting Guide.
The
Error Code Troubleshooting Guide
contains the following information:
Experience Series 700 Line Treadmills
140
6Troubleshooting
To Next Page
Loading...
Need help?
General