Information Display (65)
Service Access Code: 6,5 (see "Service Access Codes" on page๎17)
The Information Display (๎6,5) is only supported on P10, P20, and P30 consoles.
The Information Display menu provides information about the machine hardware and soft-
ware, the equipment usage stats, the ASL maintenance reminder settings, and the error
codes (Error Log).
P10, P20, and P30 Series Consoles
METRIC DESCRIPTION
ODOMETER The total number of accumulated miles on the unit.
This value is stored in the upper PCA in the console so if
the PCA is replaced the accumulated miles would start
again from "0".
HOUR METER The total number of hours that the unit took to accumulate
unit miles.
This value is stored in the upper PCA in the console so if
that PCA is replaced the hours of use would start again
from "0".
BELT RATING
(2)
Displays the belt rating from 10 (best) to 0 (worst). Reset-
table to 10 by holding down QuickStart.
MAINT COUNTER Hours remaining until maintenance is required (initializes
to 250 hrs, approximately 1 month use).
Press/Hold the PAUSE/RESET key to reset the counter.
U-BOOT SW The console Upper Boot software version information.
U-BASE SW The console Upper Base software version information.
METRICS BOARD SW The console Metrics board software version information
SER NUMBER Displays the model and serial number of the machine. The
base serial number can be set using the WinCSAFE com-
puter software. The factory default is NONE.
USAGE LOG Displays the type of workout programs the users are
accessing most frequently.
"Error Log & CPA Event Log"
on page๎145
Table of stored error event codes.
TIP: You can quickly access the Error log by holding down
the PAUSE key. Will show the STUCK KEY message
when there are no logged error codes.
TREADMILL
MAINTENANCE
(1)
Used to monitor and reset the 1000 mile belt cleaning main-
tenance reminder. Mileage counter starts at 1000 miles
and decreases to 0 miles which triggers a blue pulsing ASL
light indicating itโs time for belt cleaning maintenance.
Experience Series 700 Line Treadmills
33
3 Standard Service Modes
Information Display (65)