MAINTENACE
PARAMETER
DESCRIPTION
» Operating Condition menu: Maintenance > Recommended Action > Operating
Condiiton
Range: Good, Inspect
Good: No maintenance required.
Inspect: There is an issue with the running belt/deck that requires
maintenace service or replacement.
» Belt Rating menu: Maintenance > Recommended Action > Belt Rating
Range: 10 - 0 (10- New condition, 0 or 1 - Replace running belt)
A belt rating of 0 or 1 will cause a blue pulsing ASL light indicating
that there is a problem with the running belt/deck and is in need of
servicing or replacement.
» Next Maintenance
Due
menu: Maintenance > Recommended Action > Next Main-
tenance Due
Provides machine maintenance status:.
Active Status Light
(ASL)
menu: Maintenance > Active Status Light
Indicates the machine operating and maintenance status, see "
Active Status Light (ASL)" on page147.
Blue Solid: Normal operation Indicates that the ASL has not
detected any logged error codes.
Blue Pulsing: Preventative maintenance reminder.
• Treadmills: A belt rating of 0 or 1 will cause a blue pulsing ASL
light indicating that there is a problem with the running belt/deck
and is in need of servicing or replacement.
• ALL : The maintenance counter starts at 1000 hours counting
down to active use hours to 0 indicating indicating preventative
maintenance is due.
Yellow Solid: Indicates an error has occurred, was self-corrected
and the machine can be used. The fault can be cleared.
Yellow Pulsing There is a current non-recoverable fault con-
dition, there is a loss of a major function and the machine id out-of-
service. Machine service is required.
» AS light Brightness menu: Maintenance > Active Status Light > AS Light Bright-
ness
Range: low, medium, bright
Adjust the ASL brightness level.
» Maintenance
Reminder
menu: Maintenance > Active Status Light > Maintenance
Reminder
Range: OFF/ ON (default)
Switch the mainenance reminder function ON or OFF.
Experience Series 700 Line Treadmills
32
3 Standard Service Modes
Club Settings Service mode (5651565)
To Next Page
Loading...
