On P10, P20, and P30 consoles:
Access Hardware Validation (5,1,7,6,5,7,6,1) > AS LIGHT BRIGHTNESS > select HIGH,
MED, LOW, or OFF.
On P62, P80, and P82 consoles:
Access Club Settings (5,6,5,1,5,6,5) > Maintenance menu > AS LIGHT BRIGHTNESS >
select HIGH, MED, or LOW.
Disabling the ASL Maintenance Reminder
When set to ON, the ASL maintenance reminder - pulsing blue light state is triggered ON
when the maintenance counter counts down to zero miles (or zero hours). When set to OFF,
the ASL Maintenance Remindercounter is ignored and the ASL state is not changed to
pulsing blue.
l The "OFF" setting effectively disables the ASL "blue pulsing" state without affecting the
yellow or pulsing yellow fault states.
l When set to OFF, the Maintenance Reminder counter continues counting down the
miles (or hours) remaining which can be viewed in the service access menu, see "View-
ing the current ASL state" below.
l Error code events will still affect the ASL state condition even when the Maintenance
Reminder is set to OFF.
On P10, P20, and P30 consoles:
Access Club Settings (5,6,5,1,5,6,5) > MAINT CONFIG > select ON or OFF.
On P62, P80, and P82 consoles:
Access Club Settings (5,6,5,1,5,6,5) > Maintenance menu > Maintenance Reminder >
select ON or OFF
Viewing the current ASL state
The current ASL state (solid blue, pulsing blue, solid yellow; or pulsing yellow) can be viewed
using the service menu ACTIVE STATUS LIGHT parameter.
On P10, P20, and P30 consoles:
Access Hardware Validation (5,1,7,6,5,7,6,1) > ACTIVE STATUS LIGHT > current ASL
state.
On P62, P80, and P82 consoles:
Access Club Settings (5,6,5,1,5,6,5) > Maintenance menu > ACTIVE STATUS LIGHT >
current ASL state.
Viewing the ASL maintenance counter remaining miles (or hours)
The maintenance counter remaining miles or hours to zero can be viewed in the service menu.
Experience Series 700 Line Treadmills
150
6Troubleshooting
To Next Page
Loading...
Need help?
General