Precor TRM700-16 Base - Drive Belt Replacement; About; Procedure

Drive Belt Replacement
About
This procedure provides instruction to remove and install the Drive Belt
Procedure
Review entire procedure before starting.
Removal Instructions
1. Switch the power OFF and unplug
1
the power cord.
2. Remove the hood cover, see "Covers and Panels Replacement" on page54.
3. Remove the left and right trim landing covers, see "Trim Landing Covers Replacement"
on page59.
4. Relax the running belt tension by loosening the left and right 5/16" hex key tension
adjustment bolts. Alternately loosen the left and right adjustment bolts in 1/4 turn
1
Disconnect a device power cord plug or cable connector from the power receptacle or outlet.
Experience Series 700 Line Treadmills
94
5 Replacement Procedures
Drive Belt Replacement