1. Remove the hood cover, see "Hood Cover Replacement" on page56.
2. Use a 1/4" socket to loosen the right side power cord cable clamp fastener. Then loosen
the inner cable clamp fastener until the clamp can be slide over the power cord plug.
Then disconnect and remove the power cord. In some cases the inner clamp fastener
may need to be completely removed. Retain fastener hardware for installation.
Installation Instructions
1. Connect the replacement power cord into the power cord AC input assembly.
2. Position power cord cable clamp over the power cord plug and fully tighten the clamp
fasteners.
3. Reinstall the hood cover, see "Hood Cover Replacement" on page56.
4. Connect the power cord and switch the ON/OFF circuit breaker ON.
5. Do the Operation Verification tests (see "Operation Verification" on page15) and return
to service.
Experience Series 700 Line Treadmills
74
5 Replacement Procedures
Power Cord Replacement
To Next Page
Loading...
