Primes PROFINET - Page 89

PowerMeasuringModule PMM
35,0(6
89
Revision 13 EN - 02/2023
1)
Please read the information on the identification plate to determine if your device is equipped with a
standard or an advanced absorber.
The identification plate shows as an example the PowerMeasuringModule PMM PROFINET
®
.
Standard absorber (without mark “A”) Advanced absorber (with mark “A”)
The configuration of your device with the possibility to measure pulsed lasers and a reduced thermalization
time can be found on the identification plate.
The identification plate shows as an example the PowerMeasuringModule PMM PROFINET
®
.
With the AP3s marking, pulsed lasers can also be measured and the device is designed for a reduced thermalization
time. The device is equipped with an advanced absorber.
1)
Please read the information on the identification plate to determine if your
PMM PROFINET
®
LWL (Fiber optics) with UL marking is equipped with a standard or advanced absorber.
The type of absorber is indicated on the identification
plate.
The type of absorber is indicated on the identification
plate.
The configuration of your device with the possibility to measure certain wavelengths can be found on the
identification plate.
The identification plate shows as an example the PowerMeasuringModule PMM PROFINET
®
.
A “BG” mark indicates that the device is suitable for measuring blue/green wavelengths.
Without the “BG” mark, the device is suitable for measuring NIR wavelengths.
The measurable wavelengths are marked on the lower edge of the identification plate.